On this page

What It Does

In the app, this alert is called Target detected, on the trap's settings, in your notification settings, in Activity, and in the Inbox.

When enabled and the trap is in Armed Mode, a Target detected alert tells you when an animal is detected approaching the trigger point. This early warning system sends a notification and a photo (if applicable), helping you stay ahead of trap activity.

How It Works

OcuTrap uses a distance sensor to detect animals before they reach the capture point. It watches two areas:

  • Detection area (out to about 34 in / 875 mm from the sensor): The trap tracks an approaching animal and may send a Target detected alert with a photo.
  • Capture point (your capture-distance setting; default 8 in / 200 mm): The door closes once the animal is confirmed at or inside this distance.

Default capture distance is 8 inches (200 mm), adjustable from 6 to 18 inches in the app. Target detected alerts can fire while an animal is still approaching in the detection area, before the door closes.

Example

With the default 8 in (200 mm) capture distance:

  • As the animal approaches within the detection area (out to ~34 in), you may receive a Target detected alert with an approach photo.
  • At ~8 in (200 mm) or closer, the trap confirms capture and the door closes.

A push notification or an email for it is titled Target Detected. In the Inbox it reads, for example, "North fence target detected", and in Activity it is a Target detected row with the distance, for example "Detected at 17 in." It tells you an animal is approaching before a capture happens and includes an approach photo when available. In Scouting mode the same approach event shows as a Scout Alert instead. The distance the animal was detected at is recorded on the event details.

Units (inches or centimeters) in the alert depend on the trap's Metric units in trap alerts setting. For the full sensor model, see Technical specifications.

How to Enable or Disable

This setting is configured per trap:

  1. Open the OcuTrap app or base.ocutrap.com
  2. Tap on the trap you want to edit
  3. Open the trap's Settings (in the mobile app, tap More, then Settings)
  4. Find Target detected, near the top with the everyday settings.
  5. Toggle to On or Off
  6. Select Save and sync (Save & Sync in the mobile app) to send the change to the trap

Default setting: On

Why Use This Feature?

  • See what’s approaching your trap before it’s too late
  • Detect non-target animals early (like pets or skunks)
  • Monitor animal behavior without needing a capture, or use Scouting mode to watch activity without closing the door
  • Improve trap placement and setup based on activity patterns

What you'll see (alert motion gate, firmware v906+)

SignalWhen it fires
Target detected alertAfter the animal shows real inward movement (~3 in / 75 mm) toward the trap: static grass or debris in the detection zone will not trigger the alert
Approach photosOn zone entry and during approach: not blocked by the motion gate that holds the alert
Door closeOnly when the animal is confirmed in the capture zone (Armed mode)

Testing tip: To check the alert, arm the trap with the door open and slowly move an object on a stick toward the opening, keeping your hands clear of the door. Never reach into an armed trap. To test without the door closing, use Scouting mode: it uses the same motion gate, and the approach shows as a Scout Alert in the feed instead of a notification. Approach photos are not held by the gate.

Need to Turn It Off?

If you prefer to only be notified after a capture, turn off Target detected in the trap's settings at any time. To stop receiving it from every trap without changing the traps, turn off your own Target detected switch in Notification settings. It will not affect the actual capture or release functions.