Troubleshooting

Applies to OcuTrap R1 and R2

What Safe Mode is for: Safe Mode is a recovery mode built into the trap's cellular controller. In Safe Mode the device still starts up and connects to the cloud, but it does not run the trap's normal program. That lets it accept a firmware update (or clear a bad state) when the trap is stuck in a crash or boot loop and won't come online on its own. It's an advanced step. You normally only need it when OcuTrap Support asks you to use it while recovering a device.

While in Safe Mode the LED shows breathing magenta (the same firmware-update color you'll see in the LED guide).

Buttons: Safe Mode uses the blue Mode button (labeled MD) and the white Reset button (labeled RST) inside the POD. They sit next to the red Power and green User buttons you use every day; see the diagram.

Prerequisite: Make sure the device has enough battery charge. If it will not turn on, charge the battery and try again.

To put your device in Safe Mode:

  1. Hold down both the white Reset and blue Mode buttons.
  2. Release only Reset, and keep holding Mode.
  3. Wait for the LED to start blinking magenta.
  4. Release Mode as soon as it blinks magenta.

The trap then connects: blinking green, then blinking cyan. Breathing magenta confirms Safe Mode is active. If the trap cannot connect to the cloud, you may not see breathing magenta. If the LED is blinking magenta after you release Mode, a firmware update is more likely in progress.

If you're not sure whether your trap needs Safe Mode, contact support before using it.